Panasonic-SAVK950EE-cs-sm 电路图 维修手册.pdf
《Panasonic-SAVK950EE-cs-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Panasonic-SAVK950EE-cs-sm 电路图 维修手册.pdf(144页珍藏版)》请在收音机爱好者资料库上搜索。
1、n AMPLIFIER SECTION RMS Output Power: Dolby Digital Mode Front - High Ch110 W per channel (3 ), 1 kHz, 10% THD Front - Low Ch55 W per channel (6 ), 100 Hz, 10% THD Surround Ch110 W per channel (3 ), 1 kHz, 10% THD Center Ch110 W per channel (3 ), 1 kHz, 10% THD Subwoofer Ch110 W per channel (3 ), 10
2、0 Hz, 10% THD Total RMS Dolby Digital mode power 880 W PMPO output power10000 W n FM/AM TUNER, TERMINALS SECTION Preset stationsFM 15 stations AM 15 stations Frequency Modulation (FM) Frequency range87.50 MHz to 108.00 MHz (50-kHz step) Sensitivity4.0 V (IHF) S/N 26 dB2.2 V Antenna terminals75 (unba
3、lanced) 2006 Matsushita Electric Industrial Co. Ltd. All rightsreserved.Unauthorizedcopyingand distribution is a violation of law. SA-VK950EE Colour (S). Silver Type Amplitude Modulation (AM) Frequency range522 kHz to 1629 kHz (9-kHz step) AM sensitivity S/N 20 dB at 999 kHz 1000 V/m Phone jack Term
4、inalStereo, 3.5-mm jack Mic jack Sensitivity0.7 mV, 600 TerminalMono, 6.3-mm jack (2 system) Music Port jack (Front) Sensitivity100-mV, 4.7 k TerminalStereo, 3.5-mm jack n CASSETTE DECK SECTION TypeAuto Reverse Track system4-Track, 2 Channel Head Record/PlaybackSolid permalloy head ErasureDouble Gap
5、 Ferrite Head MotorDC Servo Motor Recording systemAC Bias 100 kHz Erase SystemAC Erase 100 kHz Tape Speed4.8 cm/s Overall Frequency Response (+3, -6 dB) at DECK OUT Normal35 Hz to 14 kHz DVD Stereo System Notes: This models DVD mechanism changer unit is CRS1D. Please refer to the original Service Ma
6、nual (Order No. MD0603065A3) for this mechanism. Specifications ORDER NO. MD0607237CE RadioFans.CN 收音机爱 好者资料库 S/N Ratio50 dB (A weighted) Wow and Flutter0.18% (WRMS) Fast Forward and Rewind TimeApprox. 120 seconds with C-60 cassette tape n DISC SECTION Disc played 8 cm or 12 cm (1) DVD (DVD-Video, D
7、ivX) (2) DVD-RAM (DVD-VR, JPEG, MP3, MPEG4, DivX) (3) DVD-R (DVD-Video, DVD-VR, JPEG, MP3, MPEG4, DivX# 1,#2) (4) DVD-R DL (DVD-Video, DVD-VR) (5) DVD-RW (DVD-Video, DVD-VR, JPEG, MP3, MPEG4 2,#5, DivX# 1,#2) (6) +R/ +RW (Video) (7) +R DL (Video) (8) CD,CD-R/RW CD-DA, Video CD, SVCD, MP3, WMA, JPEG#
8、 2,#3, MPEG4# 2,#5, DivX# 1,#2, HighMAT Level 2 (Audio and Image) Plays all versions of DivXvideo (including DivX 6) with standard playback of DivXmedia files. Certified to the DivX Home Theater Profile. GMC (Global Motion Compensation) is not supported. The total combined maximum number of recogniz
9、able audio, picture and video contents and groups: 4000 audio, picture and video contents and 400 groups. Exif Ver 2.1 JPEG Baseline files Picture resolution: between 160 x 120 and 6144 x 4096 pixels (Sub sampling is 4:0:0, 4:2:0, 4:2:2 or 4:4:4). Extremely long and narrow pictures may not be displa
10、yed. MPEG-1 Layer 3, MPEG-2 Layer 3 MPEG4 data recorded with the Panasonic SD multi cameras or DVD video recorders. Conforming to SD VIDEO specifications (ASF standard) / MPEG4 (Simple Profile) video system / G.726 audio system Conforming to IEC62107 Windows Media Audio Ver. 9.0 L3 Not compatible wi
11、th Multiple Bit Rate (MBR) Pick up Wavelength (DVD/CD)662 nm/785 nm Laser power (DVD/CD)CLASS 1 / CLASS 1M Audio output (Disc) Number of channels(FL, FR, C, SL, SR, SW), 5.1 ch Audio performance (measurement at: Rec out terminal) Frequency response (CD-Audio)4 Hz to 20 kHz n VIDEO SECTION Video syst
12、em Signal systemPAL625/50, PAL525/60, NTSC Composite video output Output level1 Vp-p (75 ) TerminalPin jack (1 system) S-video output Y output level1 Vp-p (75 ) C output level0.3 Vp-p (75 ) (PAL) 0.286 Vp-p (75 ) (NTSC) TerminalS terminal (1 system) Component video output NTSC : 480p / 480i, PAL: 57
13、6p / 576i Y output level1 Vp-p (75 ) PBoutput level0.7 Vp-p (75 ) PRoutput level0.7 Vp-p (75 ) Terminal Pin jack (Y: green, PB: blue, PR: red) (1 system) n GENERAL Power supplyAC 230 V, 50Hz Power consumption360 W Power consumption in standby mode: 0.5 W (approximate) Dimensions (W x H x D)250 x 330
14、 x 334.6 mm Mass5.5 kg Operating temperature range+ 5 to + 35C Operating humidity range5% to 90% RH (no condensation) n SYSTEM For information on speaker system, please refer to the original Service Manual (Order No. MD0605195C3) for SB-VK950GC1-S, (Order No. MD0605194C3) for SB-PC950GC-S, (Order No
15、. MD0605199C3) for SB-PS950GC-S QZZCWAT 14.1.1. Head Azimuth Adjustment (Deck 1/2) Caution: Please replace both azimuth adjustment screw and springs simultaneously when readjusting the head azimuth. (shown in Fig. 2) Even if you wish to readjust the head azimuth without replacing the screws and spri
16、ngs, a fine adjustment to the azimuth screw and spring. Please remove the screw-locking bond left on the head base when replacing the azimuth screw. If you wish to readjust the head azimuth, be sure to adjust with adhering the cassette tape closely to the mechanism by pushing the center of cassette
17、tape with your finger. (shown in Fig. 3) 1. Playback the azimuth adjustment portion (8 kHz, -20dB) of the test tape (QZZCFM) in the forward play mode. Vary the azimuth adjustment screw until the output of the R-CH (PB OUT-R) are maximized. 2. Perform the same adjustment in the reverse play mode. 3.
18、After the adjustment, apply screwlock (NEJI-LOCK) to the azimuth adjusting screw. Screw-Lock applied on the screw must be more than 180 around screw. 14.1.2. Tape Speed Adjustment (Deck 1/2) 1. Set the tape edit button to “NORMAL” position. 2. Insert the test tape (QZZCWAT) to DECK 2 and playback (F
19、WD side) the middle portion of it. 3. Adjust Motor VR (DECK 2) for the output value shown below. Adjustment target: 2910 3090 Hz (NORMAL speed) 4. After alignment, assure that the output frequency of the DECK 1 FWD are within 90 Hz of the value of the output frequency of DECK 2 FWD. Fig. 1 14.1.3. B
20、ias Voltage Check 1. Set the unit “AUX” position. 2. Insert the Normal blank tape (QZZCRA) into DECK 2 and the unit to “REC” mode (usekey). 3. Measure and make sure that the output is within the standard value. Bias voltage for Deck 2144mV (Normal) 14 Adjustment Procedures 63 SA-VK950EE Fig. 2 Fig.
21、3 No adjustment is required. 14.3.1. Cassette Deck Section 14.1.4. Bias Frequency Adjustment (Deck 1/2) 1. Set the unit to “AUX” position. 2. Insert the Normal blank tape (QZZCRA) into DECK 2 and set the unit to “REC” mode (usekey). 3. Adjust L1002 so that the output frequency is within the standard
22、 value. Standard Value: 89 110 kHz Fig. 4 14.2. Tuner section 14.3. Alignment Points 64 SA-VK950EE 15 Voltage and Waveform Chart Note: Circuit voltage and waveform described herein shall be regarded as reference information when probing defect point, because it may differ from an actual measuring va
23、lue due to difference of Measuring instrument and its measuring condition and product itself. 65 SA-VK950EE 15.1. DVD Module P.C.B. 66 SA-VK950EE 67 SA-VK950EE 15.2. Main P.C.B. 68 SA-VK950EE 69 SA-VK950EE 70 SA-VK950EE 15.3. Panel P.C.B. 71 SA-VK950EE 15.4. Deck P.C.B. H=ON) 75JOG_BISignal B from V
24、olume JOG 76JOG_AISignal A from Volume Jog 77N.C.-No Connection 78DECK1_HOHigh when Deck1 playback head is selected 79PLUNGER1ODeck1 Plunger Control (L=OFF; H=ON) 80PLUNGER2ODeck2 Plunger Control (L=OFF; H=ON) 81MODEL_CSIToselectModelwhen power on (VK750=H; VK850/950=L) 82N.C.-No connection 83(VK750
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Panasonic-SAVK950EE-cs-sm 电路图 维修手册 Panasonic SAVK950EE cs sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


