Marantz-SR8400-avr-mz07053 电路图 维修手册.pdf

《Marantz-SR8400-avr-mz07053 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Marantz-SR8400-avr-mz07053 电路图 维修手册.pdf（2页珍藏版）》请在收音机爱好者资料库上搜索。

1、 100 Corporate Drive Mahwah, NJ 07430 Service Bulletin No. : MZ07-053 Date: May 10, 2007 _ Model: SR7400, SR8400 Subject: Software Update Symptom: Update the software to minimize component over dissipation when the power amp has failed. Solution: 1. Change the procedure for the circuit protection op

2、eration. Before Updating: Originally, the unit was designed to go into STANDBY mode with the STANDBY LED flickering every 500m sec. upon detection of an abnormality. The unit would never be powered on by the standby switch or the remote control, so over dissipation never occurred. However, if the un

3、it was unplugged and plugged in again, component over dissipation could occur before the unit went into standby a few seconds later. After Updating: The unit has been modified never to be powered on by any means once it goes into standby with the standby led flickering every 125m sec., unless a spec

4、ialized procedure (*1 described below) is performed. Specialized Procedure: *1: If the unit cannot be powered on after being plugged in again (with the STANDBY LED flickering every 125m seconds), the power amp has failed. The unit still can be powered on again through the following method, but it ca

5、n further damage the power amplifier. Never let end-users perform this procedure. _ CONFIDENTIALITY NOTICE: The information contained in this document is intended for the exclusive use by MARANTZ Authorized Service Centers and their employees. This document may contain information that is privileged

6、, confidential and may be protected from disclosure under applicable laws and terms of the MARANTZ Service Agreement. Any distribution, disclosure, dissemination or copying of this document and the information it contains is prohibited. No responsibility will be accepted by MARANTZ for any damage, i

7、njury or loss resulting from the misuse of the information contained in this document. RadioFans.CN 收音机爱 好者资料库 Can be powered on by “FACTORY KEY”=PURE DIRECT+7.1 CH INPUT+CLEAR 2. Update the MAIN microprocessor firmware. After the update, please refer to the firmware version history. If it is found

8、to be not yet updated, please perform the latest update. a.) For the firmware version check procedure, refer to the Service Manual on Page 8 of the Service Mode. 3. Update Software: a.) Firmware Ver.:SR7400_0703143.mot (For the procedure, please refer to the Service Manual on Page 61). Parts: Ref# D

9、escription Part Number NA Firmware, SR7400_0703143.mot 00M37AW499A02 Serial Number Range: Please implement the modification on all units returned for repair. _ CONFIDENTIALITY NOTICE: The information contained in this document is intended for the exclusive use by MARANTZ Authorized Service Centers a

10、nd their employees. This document may contain information that is privileged, confidential and may be protected from disclosure under applicable laws and terms of the MARANTZ Service Agreement. Any distribution, disclosure, dissemination or copying of this document and the information it contains is prohibited. No responsibility will be accepted by MARANTZ for any damage, injury or loss resulting from the misuse of the information contained in this document. RadioFans.CN 收音机爱 好者资料库