Onkyo-DTR7_3-avr-sm 电路图 维修手册.pdf
《Onkyo-DTR7_3-avr-sm 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Onkyo-DTR7_3-avr-sm 电路图 维修手册.pdf(4页珍藏版)》请在收音机爱好者资料库上搜索。
1、DTR-7.3 SERVICE MANUALSERVICE MANUAL AV RECEIVER Black model MODEL DTR-7.3 120V AC, 60Hz 230240V AC, 50Hz BUDD BUPA Ref. No. 3758 Nov., 2002 SAFETY-RELATED COMPONENT WARNING! COMPONENTS IDENTIFIED BY MARK ON THE SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK
2、. REPLACE THESE COMPONENTS WITH ONKYO PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL. MAKE LEAKAGE-CURRENT OR RESISTANCE MEASUREMENTS TO DETERMINE THAT EXPOSED PARTS ARE ACCEPTABLY INSULATED FROM THE SUPPLY CIRCUIT BEFORE RETURNING THE APPLIANCE TO THE CUSTOMER. RadioFans.CN 收音机爱 好者资料库 DTR-
3、7.3 SPECIFICATIONS AMPLIFIER SECTION Continuous average power output (FTC) All channels:100 W per channel min. RMS at 8 Ohm , 2 channels driven from 20Hz to 20 kHz with no more than 0.08% total harmonic distortion. 130 W min. RMS at 6Ohm , 2 channels driven from 1 kHz with no more than 0.1% total ha
4、rmonic distortion. Continuous power output (DIN)135 W at 6 Ohm Maximum power output (EIAJ)160 W at 6 Ohm Dynamic power output (stereo)2 x 250 W at 3 Ohm 2 x 210 W at 4 Ohm 2 x 130 W at 8 Ohm Total harmonic distortion:0.08% at rated power 0.08% at 1 W output IM distortion:0.08% at rated power 0.08% a
5、t 1 W output Damping factor:60 at 8 Ohm Input sensitivity and impedance PHONO:2.5 mV, 50 kohm LINE (CD, TAPE, DVD, VIDEO 1-5):200 mV, 50 kohm MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R, SURROUND BACK L/R): 200 mV, 50 kohm (SUBWOOFER):36 mV, 50 kohm COAXIAL 1, 2, 3 (DIGITAL):0.5 Vp-p, 75 Ohm DVD,
6、VIDEO 1, 2, 3, 4, 5:1 Vp-p, 75 Ohm 1 Vp-p, 75 Ohm (Y) 0.28 Vp-p, 75 Ohm (C) COMPONENT VIDEO 1, 2:1 Vp-p, 75 Ohm (Y) 0.7 Vp-p, 75 Ohm (PB, PR) Output level and impedance Rec out (TAPE, VIDEO 1, 2): 200 mV, 470 Ohm Pre out:1 V, 470 Ohm VIDEO (VIDEO 1, 2, MONITOR OUT, ZONE 2 OUT):1 Vp-p, 75 Ohm 1 Vp-p,
7、 75 Ohm (Y) 0.28 p-p, 75 Ohm (C) COMPONENT VIDEO OUT:1 Vp-p, 75 Ohm (Y) 0.7 Vp-p, 75 Ohm (PB, PR) Phono overload:120 mV RMS at 1 kHz, 0.5% T.H.D. Frequency response:5 Hz to 100 kHz : +1/ -3 dB (CD in Direct mode) RIAA deviation:20 Hz to 20 kHz : 0.8 dB Tone Control Bass:10 dB at 50 Hz Treble:10 dB a
8、t 20,000 Hz Signal-to-noise ratio (Direct) Phono:80 dB (IHF A, 5 mV input) Line:110 dB (IHF A, 0.5 V input) Muting:Due to setup menu TUNER SECTION FM Tuning range USA & Canadian models:87.5108.0 MHz (100-kHz steps) Australian models:87.50 108.00 MHz (50-kHz steps) Usable sensitivity Mono:11.2 dBf, 1
9、.0 V (75 Ohm IHF) 0.9 V (75 Ohm DIN) Stereo:17.2 dBf, 2.0 V (75 Ohm IHF) 23 V (75 Ohm DIN) 50 dB quieting sensitivity Mono:17.2 dBf, 2.0 V (75 Ohm ) Stereo:37.2 dBf, 20 V (75 Ohm ) Capture ratio:2.0 dB Image rejection ratio USA & Canadian models:40 dB Australian models:85 dB IF rejection ratio:90 dB
10、 Signal-to-noise ratio Mono:76 dB Stereo:70 dB Alternate channel attenuation:55 dB Selectivity:50 dB (DIN) AM suppression ratio:50 dB Total harmonic distortion Mono:0.2% Stereo:0.3% Frequency response:30 Hz15 kHz, 1.0 dB Stereo separation:45 dB at 1 kHz 30 dB at 100 Hz10 kHz AM Tuning range USA & Ca
11、nadian models:530 to 1,710 kHz (10-kHz steps) Autralian models522 to 1,611 kHz (9-kHz steps) Usable sensitivity:30 V Image rejection ratio:40 dB IF rejection ratio:40 dB Signal-to-noise ratio:40 dB Total harmonic distortion:0.7% GENERAL Power supply USA & Canadian models:AC 120 V, 60 Hz Australian m
12、odels:AC 230 240 V, 50 Hz Power consumption USA & Canadian models:8.1 A Australian models:655 W Dimensions (W x H x D):435 x 175 x 460 mm 17-1/8x 6-7/8x 18-1/18 Weight:38.4 lbs. (17.4 kg) REMOTE CONTROLLER Transmitter:Infrared Signal range:Approx. 16 ft., 5 meters Power supply:Two “AA” batteries (1.
13、5 V x 2) Specifications and features are subject to change without notice. RadioFans.CN 收音机爱 好者资料库 DTR-7.3 SERVICE PROCEDURES 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continued protection against fire hazard, replace with same
14、 type fuse. For fuse rating refer to the marking adjacent to the symbol. Ce symbole indique que le fusible utlise est a rapide. Pour une protection permanente, nuntiliser que fusibles de meme type. Ce darnier est la qu le present symbol est appse. CIRCUIT NO. PART NO. DESCRIPTION 2. To initialize th
15、e unit This device employs a microprocessor to perform various functions and operations. If interference generated by an external power supply, radio wave, or other electrical source results in accident which causes the specified operations and functions to operate abnormally. To perform a result, p
16、lease follow the procedure below. 1.Press the STANDBY ON button to turn on the unit. 2.Press and hold down the VIDEO 1 button, then press the STANDBY/ON button. 3.After CLEAR is displayed, the preset memory and each mode stored in the memory, such as surround, are initialized and will return to the
17、factory setting. 4.Unplug the power supply cord. 3. Safety-check out (Only U.S.A. model) After correcting the original service problem, perform the following safety check before releasing the set to the customer. Connect the insulating-resistance tester between the plug of power supply cord and scre
18、w on the back panel. Specifications: 3.3Mohm+/-10% at 500V. 4. Memory Preservation This unit does not require memory preservation batteries. A built-in memory power back-up system preserves the contents of the memory during power failures and even when the unit is unplugged. The unit must be plugged
19、 in order to charge the back-up system. The memory preservation period after the unit has been unplugged varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been unplugged. This period is s
20、horter when the unit is exposed to a highly humid climate. F6901,F6902 25219910A-UL, Fuse 25210010A-EAK, Fuse F901 25219910A-UL, Fuse F902 252077,4A-SE-EAK, 252243 or4A-SE-TL250V or 2522774A-SE-TL250V, Fuse F903 252075,2.5A-SE-EAK, 252241 or2.5A-SE-TL250V or 2522752.5A-SE-TL250V, Fuse F9501,F9502 25
21、2160 or2.5A-UL/T-237 or 2522542.5A-T/UL-ST2, Fuse 252075,2.5A-SE-EAK, 252241 or2.5A-SE-TL250V or 2522752.5A-SE-TL250V, Fuse F9503,F9504 252158 or1.6A-UL/T-237 or 2522521.6A-T/UL-ST2, Fuse 252073,1.6A-SE-EAK, 252239 or1.6A-SE-TL250V or 2522731.6A-SE-TL250V, Fuse Note: : 120V model only : Australian m
22、odel model RadioFans.CN 收音机爱 好者资料库 BLOCK DIAGRAM COMP REC/ Z2 COMP INP C REC/Z2 C INP Y R EC/Z2 RIGHT REC/Z2 YC VIDEO 1 YC S-VIDEO OUTPUT MONITOR YC VIDEO 2 YC VIDEO 5 (FRONT) YC S-VIDEO INPUT DVD YC VIDEO 1 YC VIDEO 2 YC VIDEO 3 YC VIDEO 4 MUTE MUTE ISDET VIDEO 5 L R (FRONT) ZONE2 LINEOUT L R L VID
23、EO 2 R 24.576MHZ 24.576MHZ TAPE L R DVD L R R CD L R VIDEO 3 L R VIDEO 4 L R VIDEO 1 L R VIDEO 2 L R REC OUT L TAP E R L VIDEO 1 R 1 Y CB CR INPUT 2 Y CB CR VIDEO 3 VIDEO 4 VIDEO 5 (FRONT) COMPOSITE VIDEO INPUT DVD VIDEO 1 VIDEO 2 OPTICAL 1 DIGITAL AUDIO OUTPUT EP7312 -CV ARM7 MAVER ICK MB86D41P FV
24、DECODING (AC-3,DTS) (DTS-ES) (PLII,NEO:6) MB86344BPFV POST PROCESSING (THX CINEMA) (SURR EX) AK45 28VF 96/24 2CH D/A (2/2) AK43 56VQ 192/24 6CH D/A CY7C 1019 BV33 SRAM 1M CY7C1019 BV33 SRAM1M OSD LC74 761 -9189 WM8716 96/24 D/A MX29 LV320BTC FLASH ROM 4M NM52 64165FT T SDRAM 64M HM52 64165FT T SDRAM
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Onkyo-DTR7_3-avr-sm 电路图 维修手册 Onkyo DTR7_3 avr sm 维修 手册
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


