DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf
《DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf》由会员分享,可在线阅读,更多相关《DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf(2页珍藏版)》请在收音机爱好者资料库上搜索。
1、MANUAL OF 1951 MOST-OFTEN-NEEDED RADIO DIAGRAMS Alignment Instructions for DeWald Radio Model E-520 (Circuit Diagram on page 25) To calibrate Model E-520 receiver, connect the output of a signal generator in series with a 200 mmfd. fixed condenser to the flexible antenna lead attached to the loop. C
2、onnect the low side of the generator through a 0.1 mfd. condenser to the receiver chassis. The wave band switch should be in the broad cast position. Adjust the generator to 455 KC. and adjust both I.P. transformers (both top and bottom) for maximum signal out put. Open the variable condenser for mi
3、nimum capacity. Turn the wave band switch to short wave ,fl position. Set generator at 24.2 MC. Peak the short wave $1 oscillator trimmer screw (C5) for maximum signal. Next set the generator at 25 MC. and tune in this signal on receiver. Adjust short wave #1 R.F. trimmer screw (C2) for maximum sign
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DeWald-Radio-Mfg-Corp-E-522 电路原理图 DeWald Radio Mfg Corp 522 电路 原理图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf


