AN-GRC-165_RF-301A_repair_parts_TM11-5820-759-20P_1976.pdf
《AN-GRC-165_RF-301A_repair_parts_TM11-5820-759-20P_1976.pdf》由会员分享,可在线阅读,更多相关《AN-GRC-165_RF-301A_repair_parts_TM11-5820-759-20P_1976.pdf(23页珍藏版)》请在收音机爱好者资料库上搜索。
1、TM 11-5820-759-20P TECHNICAL MANUAL ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS FOR RADIO SET AN/GRC-165 (NSN 5820-00-935-8038) HEADQUARTERS, DEPARTMENT OF THE ARMY DECEMBER 1976 TM 11-5820-759-20P TECHNICAL MANUAL HEADQUARTERS DEPARTMENT OF THE ARMY No. 11-5820-759-20PJ WASHINGT
2、ON. DC, 1 December 1976 ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LISTS FOR RADIO SET AN/GRC-165 (NSN 5820-00-935-8038) Current as of 1 July 1976 REPORTING OF ERRORS You can improve this manual by recommending improvements using DA Form 2028-2 (Test) located in the back of the manual
3、. Simply tear out the self-addressed form, fill it out as shown on the sample, fold it where shown, and drop it in the mail. If there are no blank DA Form 20282 (Test) in the back of your manual, use the standard DA Form 2028 (Recommended Changes to Publications and Blank Forms) and forward to the C
4、ommander, US Army Electronics Command, ATTN: DRSEL-MA-Q, Fort Monmouth, NJ 07703. In either case a reply will be furnished direct to you. TABLE OF CONTENTS Illus Page Figure Section I. Introduction. 2 II. Repair parts list . 5 Group 00 RadioSetAN/GRC-165 . 5 1 01 Receiver Transmitter RT-902A/GRC-165
5、 . 7 2 02 Antenna Coupler CU-1782A/GRC-165 . 12 3 03 Mounting MT-3975/GRC-165. 14 4 04 Mounting MT-3976/GRC-165 (No parts authorized) 05 Cable Assemblies (No parts authorized) 06 Microphone M - 1431GR (No parts authorized) 07 RadioSetControlC-7648A/GRC-165 . 16 6 0701 Handset H -2801GRC -165 (No par
6、ts authorized) 08 Antenna AS-2203/GRC-165. 18 6 Section III. Special tools list (Not applicable) IV. National stock number and part number index. 20 i TM 11-5820-759-20P SECTION I INTRODUCTION 1.Scope This manual lists repair parts required for performance of organizational maintenance of the AN/GRC
7、-165. 2.General This Repair Parts and Special Tools List is divided into the following sections: a.Section II. Repair Parts List. A list of repair parts authorized for use in the performance of maintenance. The list also includes parts which must be removed for replacement of the authorized parts. P
8、arts lists are composed of functional groups in ascending numerical sequence, with the parts in each group listed in figure and item number sequence. b.Section III. Special Tools List. Not applicable. c.Section IV. National Stock Number and Part Number Index. A list, in National item identification
9、number (NIIN) sequence, of all National stock numbers (NSN) appearing in the listings, followed by a list, in alphanumeric sequence, of all part numbers appearing in the listings. National stock numbers and part numbers are cross-referenced to each illustration figure and item number appearance. 3.E
10、xplanation of Columns The following provides an explanation of columns found in the tabular listings: a. Illustration. This column is divided as follows: (1)Figure number. Indicates the figure number of the illustration in which the item is shown. (2)Item number. The number used to identify each ite
11、m called out in the illustration. b. Source, Maintenance, and Recoverability Codes (SMR). (1)Source code. Source codes are assigned to sup- port items to indicate the manner of acquiring support items for maintenance, repair, or overhaul of end items. Source codes are entered in the first and second
12、 positions of the Uniform SMR Code format as follows: CodeDefinition PA-Item procured and stocked for anticipated or known usage. PB- Item procured and stocked for insurance purpose because essentiality dictates that a minimum quantity be available in the supply system. XD-A support item which is no
13、t stocked. When required, item will be procured through normal supply channels. PD- Support item, excluding support equipment, CodeDefinition cured for initial issue or outfitting and stocked only for subsquent or additional initial issues or outfittings. Not subject to automatic re- plenishment. (2
14、)Maintenance code. Maintenance codes are as- signed to indicate the levels of maintenance authorized to USE and REPAIR support items. The maintenance codes are entered in the third and fourth positions of the Uniform SMR Code format as follows: (a)The maintenance code entered in the third position w
15、ill indicate the lowest maintenance level authorized to remove, replace, and use the support item. The maintenance code entered in the third position will indicate one of the following levels of maintenance: CodeApplication/Explanation C-Crew or operator maintenance performed within organizational m
16、aintenance. O- Support item is removed, replaced, used at the organizational level. (b)The maintenance code entered in the fourth position indicates whether the item is to be repaired and identifies the lowest maintenance level with the capability to perform complete repair (i.e., all authorized mai
17、ntenance functions). This position will contain one of the following maintenance codes: CodeApplication/Explanation F- The lowest maintenance level capable of complete repair of the support item is the direct support level. D- The lowest maintenance level capable of complete repair of the support it
18、em is the depot level, per- formed by depot. Z - Nonreparable. No repair is authorized. (3)Recoverability code. Recoverability codes are assigned to support items to indicate the disposition action on unserviceable items. The recoverability code is entered in the fifth position of the Uniform SMR Co
19、de format as follows: Recoverability Definition codes Z-Nonrepairable item. When unserviceable, condemn and dispose at the level indicated in position 3. D- Reparable item. When beyond lower level repair capability, return to depot. Condemnation and disposal not authorized below depot level. F- Repa
20、rable item. When uneconomically reparable, condemn and dispose at the direct support level. 1 TM 11-5820-759-20P c.National Stock Number. Indicates the National stock number assigned to the item and will be used for requisitioning purposes. d.Part Number. Indicates the primary number used by the man
21、ufacturer (individual, company, firm, corporation, or Government activity), which controls the design and characteristics of the item by means of its engineering drawings, specifications standards, and inspection requirements, to identify an item or range of items. NOTE When a stock-numbered item is
22、 requisitioned, the repair part received may have a different part number than the part being re- placed. e.Federal Supply Code for Manufacturer (FSCM). The FSCM is a 5-digit numeric code listed in SP 708-42 which is used to identify the manufacturer, distributor, or Government agency, etc. f.Descri
23、ption. Indicates the Federal item name and, if required, a minimum description to identify the item. g.Unit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in per- forming the actual maintenance function. This measure is expressed by a two-character alphabet
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- AN GRC 165 _RF 301 A_repair_parts_TM11 5820 759 20 P_1976
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。
链接地址:http://www.radiofans.cn/p-196931.html



Marshall-9100-62-02-Schematic电路原理图.pdf


