Olympic-Radio-and-Television-Inc-407 电路原理图.pdf
《Olympic-Radio-and-Television-Inc-407 电路原理图.pdf》由会员分享,可在线阅读,更多相关《Olympic-Radio-and-Television-Inc-407 电路原理图.pdf(1页珍藏版)》请在收音机爱好者资料库上搜索。
1、VOLUME R-17, MOST-OFTEN-NEEDED 1957 RADIO SERVICING INFORMATION OLYMPIC RADIO output meter; insulated screw-driver, two .1 mfd 600 volt con densers. To insure proper alignment, a radiated signal will be required during part of the alignment procedure. To radiate a signal, connect a loop of about 6 i
2、nches in diameter (one turn of #14 or #12 wire) across the output of the signal generator, and place this loop parallel to the loop of the receiver to be aligned, at a distance of about 10 or 12 inches. Connect the output meter and signal generator as follows: Output meter: Connect across the speake
3、r voice coil and turn the volume control to maximum (extreme clockwise posi tion). Signal generator: When the generator is not used to radiate a signal, connect the low side to the receiver chassis through a .1 mfd condenser, clip the high side through a .1 mfd, 600 volt condenser to the point at wh
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Olympic-Radio-and-Television-Inc-407 电路原理图 Olympic Radio and Television Inc 407 电路 原理图
收音机爱好者资料库所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



Marshall-9100-62-02-Schematic电路原理图.pdf
crestFA901 set.zip


