Akai-RE-32-Service-Manual(1) 电路图 维修手册.pdf

《Akai-RE-32-Service-Manual(1) 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Akai-RE-32-Service-Manual(1) 电路图 维修手册.pdf（192页珍藏版）》请在收音机爱好者资料库上搜索。

1、MULTITRACK REMOTE CONTROLLER re32 Operators Manual WARNING To prevent fire or shock hazard, do not expose this appliance to rain or moisture. 000420-3 Printed in Japan RadioFans.CN 收音机爱 好者资料库 Page i The lightning flash with arrowhead symbol , within an equilateral triangle, is intended to alert the

2、user to the presence of uninsulated “dangerous voltage” within the products enclosure; that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intented to alert the user to the presence of important operating and

3、maintenance (servicing) instruc- tions in the literature accompanying the appliance. THE SYMBOLS ARE RULED BY UL STANDARDS (U.S.A.) 5B-En WARNING! To prevent fire or shock hazard, do not expose this appliance to rain or moisture. 1-En CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER

4、 (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Important Notice The material in this document is copyright to AKAI professional M.I. Corp., and may not be quoted or reproduced in any form without written permis

5、sion from the company. LIMITED SOFTWARE WARRANTY POLICY All the software provided with, or purchased especially for, AKAI professional products has been tested for functionality. AKAI professional M.I. Corp. will make its best efforts to correct reported software defects for future releases subject

6、to technical practicabilities. AKAI professional M.I. Corp. makes no warranty or representation either expressed or implied with respect to the systems performance or fitness for a particular purpose. In no event will AKAI professional M.I. Corp. be liable for direct or indirect damages arising from

7、 any defect in the software or its documentation. Further, AKAI professional M.I. Corp. will not accept any liability for any programs, sounds, audio recording or sequences stored in or used with AKAI professional products, including the cost of recovery of such data. The warranties, remedies and di

8、sclaimers above are exclusive and take precedence over all others, oral or written, express or implied, to the extent permitted by law in the geographical area of the products use. No employee of AKAI professional M.I. Corp., agent, distributor or employee of an agent or distributor is authorised to

9、 offer any variation from this policy. Rev. 34/20/2000 RadioFans.CN 收音机爱 好者资料库 Page ii WARNING WARNING The RE32 is designed to be used in a standard household environment. Power requirements for electrical equipment vary from area to area. Please ensure that your RE32 meets the power requirements in

10、 your area. If in doubt, consult a qualified electrician or AKAI professional dealer. 120VAC 60Hz for USA and Canada 220-230/240VAC 50Hz for Europe 240VAC 50Hz for Australia PROTECTING YOURSELF AND THE RE32 Never touch the AC plug with wet hands. Always disconnect the RE32 from the power supply by p

11、ulling on the plug, not the cord. Allow only an AKAI professional dealer or qualified professional engineer to repair or reas- semble the RE32. Apart from voiding the warranty, unauthorized engineers might touch live internal parts and receive a serious electric shock. Do not put, or allow anyone to

12、 put any object, especially metal objects, into the RE32. Use only a household AC power supply. Never use a DC power supply. If water or any other liquid is spilled into or onto the RE32, disconnect the power, and call your dealer. Make sure that the unit is well-ventilated, and away from direct sun

13、light. To avoid damage to internal circuitry, as well as the external finish, keep the RE32 away from sources of direct heat (stoves, radiators, etc.). Avoid using aerosol insecticides, etc. near the RE32. They may damage the surface, and may ignite. Do not use denaturated alcohol, thinner or simila

14、r chemicals to clean the RE32. They will damage the finish. Modification of this equipment is dangerous, and can result in the functions of the RE32 being impaired. Never attempt to modify the equipment in any way. In order to assure optimum performance of your RE32, select the setup location carefu

15、lly, and make sure the equipment is used properly. Avoid setting up the RE32 in the following locations: 1.In a humid or dusty environment 2.In a room with poor ventilation 3.On a surface which is not horizontal 4.Inside a vehicle such as a car, where it will be subject to vibration 5.In an extremel

16、y hot or cold environment RadioFans.CN 收音机爱 好者资料库 Page iii WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT This equipment is fitted with an approved non-rewireable UK mains plug. To change the fuse in this type of plug proceed as follows: 1) Remove the fuse cover and old fuse. 2) Fit a new fuse whi

17、ch should be a BS1362 5 Amp A.S.T.A or BSI approved type. 3) Refit the fuse cover. If the AC mains plug fitted to the lead supplied with this equipment is not suitable for your type of AC outlet sockets, it should be changed to an AC mains lead, complete with moulded plug, to the appropriate type. I

18、f this is not possible, the plug should be cut off and a correct one fitted to suit the AC outlet. This should be fused at 5 Amps. If a plug without a fuse is used, the fuse at the distribution board should NOT BE GREATER than 5 Amp. PLEASE NOTE:THE SEVERED PLUG MUST BE DESTROYED TO AVOID A POSSIBLE

19、 SHOCK HAZARD SHOULD IT BE INSERTED INTO A 13 AMP SOCKET ELSEWHERE. The wires in this mains lead are coloured in accordance with the following code: GREEN and YELLOW EARTH BLUE NEUTRAL BROWN LIVE As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured mar

20、kings identifying the terminals in your plug, please proceed as follows: The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with the letter E or with the safety earth symbol or coloured GREEN or coloured GREEN and YELLOW. The wire which is coloured BLUE mus

21、t be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. THIS APPARATUS MUST BE EARTHED Ensure that all the terminals are securely tightened and no loose s

22、trands of wire exist. Before replacing the plug cover, make certain the cord grip is clamped over the outer sheath of the lead and not simply over the wires. 6D-En Page iv FCC WARNING This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15

23、of the FCC rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inte

24、rference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to t

25、ry to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult t

26、he dealer or an experienced radio/TV technician for help. 21B-En CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER FOR COMPLIANCE COULD VOID THE USERS AUTHORITY TO OPERATE THE EQUIPMENT. 32-En This digital apparatus does not exceed the Class B limits for radio noise emissions from

27、digital apparatus set out in the Radio Interference Regulations of the Canadian Depart- ment of Communications. 27-En AVIS POUR LES ACHETEURS CANADIENS DU RE32 Le prsent appareil numrique nment pas des bruits radiolectriques dpassant les limites applicables aux appareils numriques de la Class B pres

28、crites dans le Rglement sur le brouillage radiolectrique dict par le ministre des Communications du Canada 27-F COPYRIGHT NOTICE The AKAI RE32 is a computer-based device, and as such contains and uses software in ROMs. This software, and all related documentation, including this Owners Manual, conta

29、in proprietary information which is protected by copyright laws. All rights are reserved. No part of the software or its documentation may be copied, transferred or modified. You may not modify, adapt, translate, lease, distribute, resell for profit or create derivative works based on the software a

30、nd its related documentation or any part there of without prior written consent from AKAI professional M.I. Corp., Yokohama, Japan. VENTILATION Do not prevent the units ventilation, especially by placing the unit on the soft carpet, in a narrow space, or by placing objects on the units chassistop, s

31、ide, or rear panels. Always keep the units chassis at least 10 centimeters from any other objects. 31C-En Page v WARRANTY AKAI professional M.I. Corp. warrants its products, when purchased from an authorized AKAI professional dealer, to be free from defects in materials and workmanship for a period

32、of 12 (twelve) months from the date of purchase. Warranty service is effective and available to the original purchaser only, and only on completion and return of the AKAI professional Warranty Registration Card within 14 days of purchase. Warranty coverage is valid for factory-authorized updates to

33、AKAI professional instruments and their software, when their installation is performed by an authorized AKAI professional Service Centre, and a properly completed Warranty Registration has been returned to your AKAI professional dealer. To obtain service under this warranty, the product must, on dis

34、covery of the defect, be properly packed and shipped to the nearest AKAI professional Service Centre. The party requesting warranty service must provide proof of original ownership and date of purchase of the product. If the warranty is valid, AKAI professional will, without charge for parts or labo

35、ur, either repair or replace the defective part(s). Without a valid warranty, the entire cost of the repair (parts and labour) is the responsibility of the products owner. AKAI professional warrants that it will make all necessary adjustments, repairs and replacements at no cost to the original owne

36、r within 12 (twelve) months of the purchase date if: 1The product fails to perform its specified functions due to failure of one or more of its components. 2The product fails to perform its specified functions due to defects in workmanship. 3The product has been maintained and operated by the owner

37、in strict accordance with the written instructions for proper maintenance and use as specified in this Operators Manual. Before purchase and use, owners should determine the suitability of the product for their intended use, and the owner assumes all risk and liability whatsoever in connection there

38、with. AKAI professional shall not be liable for any injury, loss or damage, direct or consequential, arising out of the use, or inability to use the product. The warranty provides only those benefits specified, and does not cover defects or repairs needed as a result of acts beyond the control of AK

39、AI professional, including, but not limited to: 1Damage caused by abuse, accident or negligence. AKAI professional will not cover under warranty any original factory disk damaged or destroyed as a result of the owners mishandling. 2Damage caused by any tampering, alteration or modification of the pr

40、oduct: operating software, mechanical or electronic components. 3Damage caused by failure to maintain and operate the product in strict accordance with the written instructions for proper maintenance and use as specified in this Operators Manual. 4Damage caused by repairs or attempted repairs by una

41、uthorized persons. 5Damage caused by fire, smoke, falling objects, water or other liquids, or natural events such as rain, floods, earthquakes, lightning, tornadoes, storms, etc. 6Damage caused by operation on improper voltages. IMPORTANT NOTE: This warranty becomes void if the product or its softwa

42、re is electronically modified, altered or tampered with in any way. AKAI professional shall not be liable for costs involved in packing or preparing the product for shipping, with regard to time, labour or materials, shipping or freight costs, or time and expenses involved in transporting the produc

43、t to and from an AKAI professional Authorized Service Centre or Authorized Dealer. AKAI professional will not cover under warranty an apparent malfunction that is determined to be user error, or the owners inability to use the product. THE DURATION OF ANY OTHER WARRANTIES, WHETHER IMPLIED OR EXPRESS

44、, INCLUDING BUT NOT LIMITED TO THE IMPLIED CONDITION OF MERCHANTABILITY, IS LIMITED TO THE DURATION OF THE EXPRESS WARRANTY HEREIN. AKAI professional hereby excludes incidental or consequential damages, including but not limited to: 1Loss of time 2Inconvenience 3Delay in performance of the Warranty

45、4The loss of use of the product 5Commercial loss 6Breach of any express or implied warranty, including the lmplied Warranty of Merchantability, applicable to this product Page vi INTRODUCTION. 1 FEATURES . 1 ABOUT THIS MANUAL. 2 TERMINOLOGY. 3 MULTI-MACHINESYSTEM . 5 REAR PANEL. 6 SYSTEM CONNECTIONS. 7 SETTING MACHINE ID NUMBERS . 8 SETTING MACHINE ID NUMBERS - DR16pro. 8 SETTING MACHINE ID NUMBERS - DD8 . 8 POWERING UP THE RE32 SYSTEM . 9 RE32 PANEL LAYOUT. 10 VGA DISPLAY.